| Measuring Range |
Up to 500 N or 1000 N (110 or 220 lb.), adjustable
other variations possible |
| Units of Measure |
Newton (N), kilopound (Kp), pound (lb.) |
| Display |
LCD 6-digit displays force value, LCD with 4 lines for operation |
| Applied Force Accuracy |
0.3% of full scale |
| Max. Stroke |
43 mm (1.69″) |
| Pull Rates |
25, 50, 100 mm / min or high
(1″, 2″, 4″ / min or high) |
| Pulling Modes |
| Pull + Break |
normal pull test until wire breaks out (destructive test) |
| Pull + Hold |
pull to a specified force and hold for up to 120 sec (non-destructive test) |
| Pull + Return |
pull to a specified force and reduce (non-destructive test) |
| Pull + Hold + Break |
pull to a specified force and hold for up to 120 sec (non-destructive test) and pull until wire breaks |
|
| Device Data Memory |
Up to 48 jobs with 50 measurements in each job (2400 values) |
| Monitoring |
Device display output; optional WinCrimp statistical software for visual force-time-table on PC and statistical analysis |
| Setting Protection |
IP 20 |
| Print Capabilites |
Can be connected either to printer and / or via PC with WinCrimp software through RS 232 interface |
| Network |
Possibility of connecting several devices. Can also be combined with crimp force monitor and crimp-height measurement device via WinCrimp software |
| Interface |
RS 232 |
| Motor |
Motor 24 VDC |
| Power Supply |
24 VDC |
| Dimensions (L x W x H) |
405 x 205 x 130 mm
(16″ x 8″ x 5″) |
| Weight Approximately |
8 kg (18 lbs.) |
| CE-Compatibility |
The PullTester 26 fully complies with all CE and EMC equipment guidelines relative to mechanical and electrical safety and electromagnetic compatibility. |
| Note |
Specifications are subject to change without notice. |
